ELB-01 Assembly Instructions
Carefully read these instructions BEFORE assembling the Electone.
Be careful not to confuse any of the parts, and be sure to install all parts in the correct direction by following the
procedures given below.
Be sure to assemble the Electone with two or more people.
Don't use any screws other than the ones specified and included in this package. Use of incorrect screws can cause
damage and malfunction.
Be sure to tighten all screws upon completing assembly.
Make sure to perform all assembly operations on a flat surface.
To disassemble, reverse the procedures.
You need a Phillips (+) screwdriver to assemble the Electone.
1
Open the package, take out the two styrofoam pads from the both sides of the package, and carefully
place the main unit on top of the pads as shown.
Take care not to pinch AC power cord plug between the pads and Main unit.
2
Take out all parts from the package.
Please confirm that all parts shown in the illustration are provided.
When you take out the Speaker Unit, always hold the bottom of the Speaker Unit, not holding the Grill Net.
Dust Cover
Sideboard
Sideboard
(Right)
(Left)
Music Rest
Main Unit
Styrofoam pads
Take out the styrofoam pads, and
place the Main Unit on top of the pads.
Speaker
Unit
Grill Net
Attached to the Speaker Unit
Pedalboard Unit
Long screws (ø6 X 25 mm): 4 pcs.
Short screws (ø5 X 12 mm): 8 pcs.
Pedalboard cord clamps: 2 pcs.
Screw caps: 4 pcs.
Bench Board
Bench
Legs: 4 pcs.
ELB-01 Assembly Instructions
EN
1